E-steps calculator
Mark the filament, extrude a set length, measure what the extruder really moved and get the corrected e-steps.
About E-Steps Calculator
E-steps are the number of motor steps the firmware sends for each millimetre of filament. If the number is off, the extruder pushes too much or too little plastic whatever the slicer says. For the test, mark the filament about 120 mm above the extruder, extrude 100 mm with the nozzle hot, and measure how far the mark moved. If 100 mm was asked for and 96.5 mm came through, an old value of 93 becomes 96.37. Klipper users can enter their rotation distance to get the new value for that instead.
- Setting up a new extruder or a new motor.
- Fixing under-extrusion that flow changes do not cure.
- Checking an extruder after fitting a different gear.
- Getting the numbers for a Marlin or Klipper config in one step.
How to use E-Steps Calculator
Step 1
Enter the e-steps your printer has now and the length you asked for.
Step 2
Choose whether you measured the length pushed, or the mark distance before and after.
Step 3
Read the new value and set it, with M92 and M500 in Marlin.
Good to know
- Do the test with the nozzle at printing temperature, and extrude slowly, around 2 mm/s. Cold or fast extrusion gives a false result.
- Repeat the test after the change. A good result is within about 1 mm of the request, and a second round fixes small errors.
- Calibrate e-steps first, then flow. They fix different things, and flow cannot cure a wrong e-steps value.
Common questions
What is the formula?
New e-steps = old e-steps x requested length / actual length. The Klipper rotation distance moves the opposite way: new = old x actual / requested.
How do I read my current e-steps?
In Marlin, send M503 and look for the M92 line. The E number is your value. Klipper shows rotation_distance in the printer config.
Does it work for a direct drive and a Bowden?
Yes. For a Bowden, measure the mark at the extruder entry with the tube disconnected from the hot end so that the nozzle does not add pressure.