CompleteSEOTools
Home › 3D Printing Tools › 3D Print Tolerance Calculator

3D print tolerance calculator

Enter a peg or hole size, pick the kind of fit and read the diameter to model.

About 3D Print Tolerance Calculator

Printed parts never come out exactly to size, so two parts that should fit together need a gap. The right gap depends on the fit. A press fit needs almost none, a sliding fit a little, and a rotating part more. This calculator uses a small table of clearances per side, scaled by a printer factor that you can change. For a 10 mm peg with a sliding fit and a factor of 1, the hole to model is 10.30 mm. The numbers are a starting point for a test print.

  • Designing a hinge, a snap fit or a pin that must turn.
  • Making a lid fit a box.
  • Sizing holes for dowels and bearings.
  • Finding which gap to try on the first test.

How to use 3D Print Tolerance Calculator

1

Step 1

Choose whether you have the peg or the hole.

2

Step 2

Type the diameter and pick the type of fit.

3

Step 3

Adjust the printer factor if your first test was too tight or too loose.

Good to know

  • The clearances are common starting values for a desktop FDM printer, not a standard. A well tuned printer needs less, and a worn one more.
  • Holes print slightly small and pegs slightly large. The effect is bigger on small holes and on holes that print upright or on edge.
  • Print a test strip with several gaps in one go. It costs a few minutes and saves a failed part.

Common questions

What is the difference between a sliding and a free fit?

A sliding fit moves with light resistance. A free fit leaves a visible gap, so a shaft can turn without binding.

Does it work for square parts?

Yes. Use the width of the peg or the slot in place of the diameter. The gap per side is the same.

Why is the gap given per side?

The hole is bigger than the peg by twice the gap, since the gap shows on both sides of the peg.