CompleteSEOTools
Home › 3D Printing Tools › Shrinkage Calculator

Shrinkage calculator

Pick a material or measure a test cube, and get the percentage to scale the model so the part comes out the right size.

About Shrinkage Calculator

Plastic contracts as it cools, and parts come out slightly smaller than the model. The effect is small for PLA, about a third of a percent, and larger for ABS and nylon. To compensate, scale the model up by one divided by one minus the shrinkage. If a 20 mm cube measures 19.9 mm, it shrank 0.5 percent, and scaling by 100.503 percent brings it back. Choose a material for a starting value, or use a measured test print, which is more reliable.

  • Getting ABS or nylon parts to fit together.
  • Fixing parts that measure just under size.
  • Comparing the likely shrinkage of different materials.
  • Working out the model size for a target part.

How to use Shrinkage Calculator

1

Step 1

Choose from the material, or switch to a test print and type the designed and measured sizes.

2

Step 2

Optionally type a part size you want.

3

Step 3

Set the scale shown in your slicer, then print and measure again.

Good to know

  • The typical values are commonly reported ranges. They move with brand, temperature, cooling and part size, so a measured test is more reliable.
  • Shrinkage can differ between X, Y and Z. Measure along the axis that matters, or scale axes separately if your slicer allows it.
  • A part that comes out larger than the design points to too much flow, not negative shrinkage.

Common questions

What is the formula?

Scale = 1 / (1 - shrinkage). For 2 percent shrinkage that is 102.04 percent, slightly more than adding 2 percent.

Does PLA need compensation?

Rarely. The shrinkage is small, and other errors such as flow and belt tension are bigger.

Should I scale the whole model?

Only if every dimension is affected the same. For one tight fit, change that dimension instead of the whole model.