CompleteSEOTools
Home › 3D Printing Tools › Flow Rate Calculator

Flow rate calculator

Print a single-wall cube, measure the wall with calipers and enter it to get a corrected flow percentage.

About Flow Rate Calculator

The flow rate, also called the extrusion multiplier, scales how much plastic the printer pushes out for each move. If it is too high you get bulging walls and rough corners. If it is too low you see gaps and weak parts. A common check is to print a hollow cube with one wall, measure the wall in several places, and compare the average with the line width you set. The new flow is the old flow multiplied by expected over measured. A 0.45 mm wall that measures 0.48 mm gives 93.75 percent.

  • Tuning a new roll of filament.
  • Fixing walls that are thicker than they should be.
  • Checking a change in brand or colour.
  • Cleaning up over-extrusion before judging other settings.

How to use Flow Rate Calculator

1

Step 1

Enter your current flow and the wall thickness the slicer expects.

2

Step 2

Type the average of your caliper readings.

3

Step 3

Read the new flow, set it in the slicer and print the cube again.

Good to know

  • Measure at least four spots and average them. Skip the corners and the start of the wall, where the line is not even.
  • A correction above about 10 percent usually means something else is wrong, such as the e-steps, the filament diameter or the temperature.
  • Calipers read to 0.01 mm, but a printed wall is rough, so expect an uncertainty of a few hundredths.

Common questions

What formula does this use?

New flow = current flow x expected wall / measured wall. A thicker wall lowers the flow, and a thinner wall raises it.

Is the flow rate the same as e-steps?

No. E-steps set how far the extruder moves for a given command. Flow is a slicer multiplier on top. Calibrate e-steps first.

Which wall thickness should I expect?

Use the line width in your slicer, often equal to or a little above the nozzle size. Check the profile you used for the test.