Volumetric flow calculator
Enter the line width, the layer height and either a print speed or your hotend's flow limit.
About Volumetric Flow Calculator
A hotend can only melt so much plastic per second. That limit, in cubic millimetres per second, matters more than the speed in mm/s, because wide or tall lines use more plastic at the same speed. The flow is the cross-section of the line times the speed. A 0.4 mm line at 0.2 mm layer height and 60 mm/s needs 4.8 mm3/s. In the other direction, a limit of 15 mm3/s for that line allows about 187 mm/s. The result also shows how fast the filament is fed into the extruder.
- Choosing a speed that a hotend can keep up with.
- Seeing why wider or taller lines need slower speeds.
- Setting the maximum volumetric speed in a slicer profile.
- Comparing the feed rate on 1.75 and 2.85 mm filament.
How to use Volumetric Flow Calculator
Step 1
Pick speed to flow, or flow limit to top speed.
Step 2
Type the line width and layer height, and the speed or the limit.
Step 3
Read the result, and the filament feed speed shown with it.
Good to know
- Real hotend limits depend on the temperature, the filament and the nozzle. Find yours by printing a test with rising flow until the extruder clicks or the line thins.
- Slicers model a line slightly differently. The rounded option follows the common stadium shape and gives a flow a little lower than the plain rectangle.
- A limit that works for PLA will be lower for filament that melts slowly, such as PETG or TPU.
Common questions
What is a normal volumetric flow?
Small hotends often manage around 10 to 15 mm3/s with PLA. High-flow hotends claim much more. Test your own.
Does nozzle size change the limit?
The melt rate is mostly set by the heater and the melt zone, not the nozzle. A larger nozzle just lets you spend the flow on thicker lines.
Why does the line cross-section matter?
Flow is the cross-section times the speed. Double the width or the height and the same speed needs twice the plastic.