Filament drying calculator
Choose a material and type a humidity reading to see a drying temperature, a time and a plain yes, maybe or no.
About Filament Drying Calculator
Most filament absorbs moisture from the air. Wet plastic pops and hisses at the nozzle, strings badly and prints a rough surface. Nylon, PVA and polycarbonate take up water fastest, PLA and ABS the slowest. This page does not model the physics. It looks up the temperature and time ranges that are commonly quoted for each material, and compares your humidity reading with simple thresholds. For example, PETG at 45 percent relative humidity is borderline, so a short dry is sensible.
- Deciding whether a spool needs drying before a long print.
- Finding a starting temperature for a filament dryer.
- Judging a dry box from its hygrometer reading.
- Checking what to try when prints string for no clear reason.
How to use Filament Drying Calculator
Step 1
Pick the material.
Step 2
Type the humidity reading where the spool is stored, and tick the box if prints show stringing or popping.
Step 3
Read the verdict, the temperature and the time to use.
Good to know
- These are commonly quoted ranges, not rules. Your filament maker's advice comes first, and a spool or dryer that cannot take the heat should be dried cooler for longer.
- Cheap hygrometers can be off by five percentage points or more, so a borderline reading is a reason to look at the print, not a firm answer.
- Drying removes moisture but does not repair filament that was damaged by long storage in a humid room.
Common questions
Do I need to dry PLA?
Often not. PLA absorbs moisture slowly, but it can still string if it has sat open for weeks in a damp room.
What temperature is too hot?
Anything near the point where the plastic softens. A spool that sags or a cardboard core that warps was dried too hot, so go lower and run longer.
Can I trust the humidity thresholds?
They are rules of thumb used on this page. Sensitive materials such as nylon are held to a lower limit than PLA.