Plaster calculator
Type the area, the thickness and the mix ratio to see how much cement and sand to buy.
About Plaster Calculator
Plaster is a thin layer of mortar, so the quantity follows from area times thickness. That wet volume is converted to a dry volume using a factor, 1.27 by default, because the dry cement and sand take up more room than the finished plaster. The dry volume is then split by your cement to sand ratio. The result gives cement in kilograms and bags, and sand in cubic metres or cubic feet. Add wastage for rough walls.
- Buying cement and sand for a room or a house.
- Comparing 12 mm and 15 mm coats.
- Checking how much a 1:4 mix needs against a 1:6 mix.
- Estimating before you hire a plasterer.
How to use Plaster Calculator
Step 1
Enter the area to plaster and the thickness.
Step 2
Set the cement and sand parts and the wastage.
Step 3
Read the cement and sand quantities.
Good to know
- Worked example: 100 m² at 12 mm is 1.2 m³ wet. At a 1.27 factor and a 1:4 mix that is about 439 kg of cement and 1.22 m³ of sand.
- Brick and block walls soak up mortar and are rarely flat. Raise the wastage to 15 or 20 percent for old or uneven walls.
- The dry factor is an example. Your mason may use another value, so you can change it.
Common questions
What thickness is usual?
Internal plaster is often around 12 mm and external plaster around 15 to 20 mm, but it depends on the wall and your local practice.
Does this include the base coat and the finishing coat?
It treats the total thickness as one layer. Add the thicknesses together if you use two coats of the same mix.
Why 1.27?
It is a commonly used dry volume factor for mortar. Real values vary with the sand, so treat it as a planning figure.