Screw hole size calculator
Pick a metric screw and a fit to see the hole sizes to model for clearance, tapping, heat-set inserts and a counterbore.
About Screw Hole Size Calculator
Different jobs need different holes for the same screw. A clearance hole lets the screw pass through. A tap hole is the size a thread is cut or formed into. A heat-set insert goes into a hole a little bigger than its outside. The clearance sizes here follow ISO 273 and the tap hole is the nominal size minus the thread pitch. The insert sizes are commonly used starting values. For an M3 screw at normal fit you get 3.4, 2.5 and 4.0 mm.
- Modelling a part that takes M3 screws.
- Choosing between a clearance and a close fit.
- Sizing holes for brass heat-set inserts.
- Adding a pocket so a socket head sits flush.
How to use Screw Hole Size Calculator
Step 1
Pick the screw size and the clearance fit.
Step 2
Add a printer allowance if your holes come out small.
Step 3
Read the hole sizes and the table of all sizes, then model them.
Good to know
- Printed holes often come out 0.1 to 0.2 mm small. Use the allowance box once you have measured a test hole.
- Insert makers publish their own hole sizes, and they differ between brands and insert lengths. Use the supplier's sheet when you have it.
- A plastic thread is weak. For parts you will unscrew often, a heat-set insert or a nut trap lasts much longer than a tapped printed thread.
Common questions
What are the ISO 273 series?
Fine, medium and coarse are three standard clearance hole sizes for each metric screw. Normal engineering use is the medium series.
How is the tap hole worked out?
It is the nominal diameter minus the coarse thread pitch. For M3 with a 0.5 mm pitch that is 2.5 mm.
Does this cover imperial screws?
No. Only metric M2 to M8 are included.