CompleteSEOTools
Home › 3D Printing Tools › Acceleration Distance Calculator

Acceleration distance calculator

Enter the target speed and the acceleration to see how far and how long the printer takes to get there, and what a move of a given length looks like.

About Acceleration Distance Calculator

A printer cannot jump to its set speed. It ramps up at the acceleration limit, cruises, and ramps down again. At 100 mm/s and 1000 mm/s2, the ramp takes 0.1 s and covers 5 mm. A 200 mm move then cruises for 190 mm and takes 2.1 s in total. A move shorter than 10 mm never reaches full speed and forms a triangle instead, with a lower peak. This is why small details print slower than the speed setting suggests.

  • Seeing why short moves never reach the set speed.
  • Estimating how acceleration changes a print time.
  • Choosing an acceleration for fine detail.
  • Checking the distance a fast move needs at the edge of the bed.

How to use Acceleration Distance Calculator

1

Step 1

Type the target speed and the acceleration.

2

Step 2

Set a start and end speed, usually 0.

3

Step 3

Enter a move length to see the cruise phase and the total time.

Good to know

  • The calculator assumes the same acceleration up and down and a straight line. Real firmware also limits cornering speed, jerk or junction deviation, which shortens the cruise further.
  • Slicers and firmware often use different acceleration for walls, infill and travel moves. Use the value for the move you care about.
  • The time is a model. Motion planning, look-ahead buffers and the processor can change what a printer does.

Common questions

What is the formula for the distance?

Distance = (speed squared minus start speed squared) / (2 x acceleration). For 100 mm/s at 1000 mm/s2 starting from rest that is 5 mm.

What happens on a short move?

If the move is shorter than the two ramps together, the peak speed is the square root of (acceleration x length + start speed squared), and the move has no cruise.

Does this include jerk?

No. Jerk and junction deviation affect corner speeds and are set in the firmware.